| Yesterday's Weapons Forums http://www.yesterdaysweapons.com/phpBB3/ |
|
| New op rod needed question. http://www.yesterdaysweapons.com/phpBB3/viewtopic.php?f=20&t=13332 |
Page 1 of 1 |
| Author: | eliculpepper [ Fri Apr 21, 2017 2:12 pm ] |
| Post subject: | New op rod needed question. |
My M1 hasn't been working for awhile. My op rod is out of spec. The piston is too small, and Im getting too much blow by to cycle the action. Im looking for a new op rod online but not sure which one to get. Its a Springfield, sn- 3181***, made in September or October 1944. Anybody know which one to get? THanks, Eli |
|
| Author: | A square 10 [ Fri Apr 21, 2017 5:14 pm ] |
| Post subject: | Re: New op rod needed question. |
eli the sticky above has what you need -copied and pasted here - shows which parts are correct for the Garand.This would make a good sticky if I could figure out how to do it. http://battlerifle0.tripod.com/ |
|
| Author: | eliculpepper [ Sun Apr 23, 2017 5:53 pm ] |
| Post subject: | Re: New op rod needed question. |
Thanks. I appreciate it. |
|
| Author: | A square 10 [ Sun Apr 23, 2017 11:30 pm ] |
| Post subject: | Re: New op rod needed question. |
no problem - it was so easy since someone else offered it a while back , i also used it once to repair my 43 winchester that someone else is now enjoying , im happy to know that yours will be running well again soon , |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|