Yesterday's Weapons Forums http://www.yesterdaysweapons.com/phpBB3/ |
|
Putting together a CETME/G3 http://www.yesterdaysweapons.com/phpBB3/viewtopic.php?f=28&t=14592 |
Page 1 of 1 |
Author: | HalOPeridol [ Wed Jul 27, 2022 5:40 am ] |
Post subject: | Putting together a CETME/G3 |
Another project to start after I purchased a West German night vision sniper scope. Scope is operational, came with case, scope, accessories and 3 mounts. One mount is for the G3. Fopund a NOS Century CETME barreled receiver on gunpoker. I was one of the excellent early cast stainless steel receiver. Barreled with bolt and carrier. just a few more things to find to finish it off foe a fall project. |
Author: | A square 10 [ Wed Jul 27, 2022 3:43 pm ] |
Post subject: | Re: Putting together a CETME/G3 |
sounds interesting be sure to post progress |
Author: | HalOPeridol [ Wed Aug 03, 2022 9:44 pm ] |
Post subject: | Re: Putting together a CETME/G3 |
Still have parts coming in. Got a green G3 stock set to put on as well as a wood CETNE one. Dis find that an original G3 scope mount won't fit on the receiver. Almost but not wuite |
Author: | JPLee [ Thu Aug 11, 2022 3:26 pm ] |
Post subject: | Re: Putting together a CETME/G3 |
Check out the rear-sight, that's usually the problem. It sits slightly further forward then the original H&K. There's a fix which involves removing the end cap on the mount IIRC |
Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |