I got this in a trade & it needed fitting to my BP revolver. Before I dived in to fit it, I found a different style at auction that was a drop in, so this one goes. I doubt there's much interest here so I'll leave it a few days - then it goes to auction.
You get only the chambered cylinder shown - no back plate/loading gate. One of those can be found at Buffalo Arms among other places. Same gate works for 1851 & 1860 Pietta. It will very likely need fitting to function properly.
As far as I know it has never been fired or fitting attempted. I did not attempt to fit it.
SW
cylinder 004 (1024x634).jpg [ 255.96 KiB | Viewed 3938 times ]
cylinder 005 (916x1024).jpg [ 319.85 KiB | Viewed 3938 times ]
cylinder 007 (1024x708).jpg [ 195.33 KiB | Viewed 3938 times ]