Yesterday's Weapons Forums http://www.yesterdaysweapons.com/phpBB3/ |
|
Anybody Use a Lee Precision Crimp Die http://www.yesterdaysweapons.com/phpBB3/viewtopic.php?f=59&t=12139 |
Page 1 of 1 |
Author: | SWIHARTMARK [ Mon Nov 25, 2013 12:06 am ] |
Post subject: | Anybody Use a Lee Precision Crimp Die |
I don't see other manufacturer's make them, but is a Lee Precision crimp something to be used in competition shooting? Best Regards, Mark BTW, I'm a terrible roll crimper, so these dies work for me. |
Author: | shuvelrider [ Tue Dec 16, 2014 11:15 pm ] |
Post subject: | Re: Anybody Use a Lee Precision Crimp Die |
This post has sat for a year and no response to it? I use the Lee Crimp dies on some of my calibers, I like them also for uniformity in my rounds. If they work for you in your competition rounds, then keep that mojo going. |
Author: | SWIHARTMARK [ Wed Dec 17, 2014 6:13 am ] |
Post subject: | Re: Anybody Use a Lee Precision Crimp Die |
I've found that the Lee neck sizers don't always hold the bullet firmly in place when I go to seat the bullet, so crimping helps this out. Best Regards, Mark |
Author: | NebrHogger [ Wed Dec 17, 2014 9:43 am ] |
Post subject: | Re: Anybody Use a Lee Precision Crimp Die |
Having shot a lot of competition over the years, I only crimped straight wall pistol rounds like hot 44 mag. Also 38 special wadcutters for better loading. Rifle? No crimp. I taper crimped 45 auto & 9mm for consistent feeding. I've never used lee crimp dies. SW |
Author: | HerrMesser [ Wed Dec 17, 2014 11:12 am ] |
Post subject: | Re: Anybody Use a Lee Precision Crimp Die |
The only thing I crimp is 357 max if I am shooting it in my DW. For the Encore I don't need to crimp. Rad |
Author: | trap4570 [ Wed Jan 21, 2015 12:35 pm ] |
Post subject: | Re: Anybody Use a Lee Precision Crimp Die |
Crimping rifle bullets for competition doesn't do much for accuracy. Having the bullet seat with a consistant amount of force and being true to the bore is more important. Loading a round one at a time by hand is the best method. |
Author: | SWIHARTMARK [ Wed Jan 21, 2015 6:12 pm ] |
Post subject: | Re: Anybody Use a Lee Precision Crimp Die |
I actually have a Lee Loader set for 45/70. I was immediately impressed it reformed a nickel plated case partially crushed by my trapdoor falling on it. I'm hoping to see how she's made inside so I can perhaps make a similar contraption for neck sizing .557/450 and perhaps .577 Snider as well. It didn't seem real complicated. Best Regards, Mark BTW, I like the crimp dies when using Lee Precision neck sizers since they almost let the bullet drop right in the case and a bullet seater would likely do that without a bit of a crimp from their special crimp dies. |
Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |