Yesterday's Weapons Forums http://www.yesterdaysweapons.com/phpBB3/ |
|
using guides to inlett a barrel http://www.yesterdaysweapons.com/phpBB3/viewtopic.php?f=95&t=12841 |
Page 1 of 1 |
Author: | OlTom [ Sun May 24, 2015 6:21 pm ] |
Post subject: | using guides to inlett a barrel |
;D 1. get blank~ 2.Profile your blank~ 3.Measure the barrel, adjust washers to match the barrels contour~ 4.make sure your bit depth matches how you want to cut the groove~ 5.routed baseline groove....and then I handcut the rest~ 6. inletted~ i have a 45degree bit~ I have moved the guides and completely used a pony router for the entire job...but I chicken out on this piece of wood, and resorted to hand planes for the 45 and sidewalls......... hope this explains the guide and pony router techique~ marc n tomtom and WHY do it this way????? I'll let tomtom tell you................. |
Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |